There’s no gas or pilot light involved in electric water heaters. If the power to your electric water heater is off, you may have an electrical issue requiring professional assistance. … You will need to reignite a gas water heater that does not light automatically.
Is there a flame on electric water heater?
The correct flame color should be a light blue with the minimum of yellow tips. Incorrect flame color is yellow or sharp blue orange. If you see the burner flame color is yellow and lazy do the following: Provide sufficient fresh air to the water heater, especially if the unit is installed in the confined area.
Does an electric water heater have a pilot light?
Remove the access panel on the side of the water heater and look inside for a blue flame. This is called a pilot light and indicates the presence of natural gas. If you see a pilot light, you have a gas water heater. Electrical water heaters do not have pilot lights.
Does water heater flame stay on?
What Does it Do? Gas and propane fueled water heaters use a small flame to ignite the burner. This small flame is called a pilot light and it stays lit at all times. When the water heater needs to heat the water within the tank, it ignites the gas burner with the help of the pilot light.
How do you light an electric hot water heater?
Lighting A Hot Water Heater Pilot Light
- Set the temperature control. to its lowest setting.
- Set the on-off control. to the pilot setting.
- Press the hot water heater. pilot button down and. hold it.
- While looking through the the sight glass slowly press the spark generator until you here it click. You should see a spark.
Why did my electric hot water heater catch on fire?
Electric water heaters are more prone to electrical fires. The leading cause of gas water heater fires is when they leak flammable vapors into the room surrounding the equipment. … This can trigger an explosion if the vapor comes into contact with the water heater’s ignition flame or electricity.
What should my water heater flame look like?
Know what the color your flame is telling you means:
Blue – Gas burners burn blue if the ratio of fuel to air is correct. Orange – Orange flame is usually dust or dirt being burnt. Yellow – Air is not getting to the flame, this needs to be inspected immediately.
Somewhere on your electric water heater, you’ll find a reset button. It’s usually red and often located near the thermostat. It may also be hidden behind a removable metal panel on the unit—and then behind some insulation. … If your water heater now has power, you’re all set.
Why is my electric water heater not heating?
If an electric water heater is not producing hot water, it could be a simple problem like a blown fuse or tripped circuit breaker. Additionally, some electric water heaters have a circuit-style safety switch located near or on the thermostat.
Why do water heaters still have pilot lights?
* Caution: Most modern water heaters no longer use standing pilots. They use electronic ignition to ignite the gas. … If the pilot light will light but does not stay lit when the gas valve control is released, the problem could be a defective or loose thermocouple, or perhaps a faulty gas control valve.
Can a water heater explode?
If the heating element and/or thermostat were to malfunction, the temperature of the water inside the tank could increase to the point where it is producing steam. If the situation progresses, and there is no outlet for the steam, the increased pressure could cause the hot water tank to explode.
Why does my water heater flame keep going out?
The most common reason that your pilot light on your water heater keeps going out is a damaged, bent or dirty thermocouple.
Should the water heater be on pilot or on?
On gas water heaters, the pilot light makes sure that there’s always flame available when the burner needs to kick in and heat water. If you run out of gas, install a new water heater or have to shut it down for some reason, lighting the pilot is the first step to turn on a water heater.
Where is the pilot light on my electric water heater?
The pilot light on most water heaters is located at the base of the unit, below the gas control valve. Open the access panel or door to the burner chamber and look inside. There, you’ll find the pilot light tube, which should have a steady blue flame. If you don’t see the flame, the pilot light is out.
How long does it take for an electric water heater to heat up?
The average electric heater takes about twice as long as the average gas heater to fully heat up the water in its tank, so you can expect it to take between an hour and an hour and 20 minutes to heat up.
Can I light my water heater with a lighter?
Turn the water temperature dial to Low and the On/Off/Pilot dial to Pilot. Push the On/Off/Pilot dial downward with one hand while lighting the barbecue lighter with the other. Quickly hold the barbecue lighter over the end of the pipe by the burner. The flame should light instantly.